Sheep Metal Ducting: Three Practical Precautions for Installing Your Pipework
If you are planning on installing ducting in your building, you should opt for sheet metal piping. Sheet metal is favourable over fibreboard and plastic alternatives because of its intrinsic strength. In simple terms, this type of ducting is not vulnerable to distortion and damage due to mechanical stress and impact. In addition, sheet metal piping is clean and hypoallergenic. The ducting will not cause the release of harmful fibrous particles during usage. If you are interested in sheet metal ducting, consider the tips below for ideal performance after your pipework installation project.
Choose the Right Design
You should choose the right ducting design for installation in your building. Under ideal circumstances, you should order your pipework from an experienced sheet metal fabricator. Custom ducting will fit perfectly into your structure because you can take into account the intended installation space before making your order. Also, you can choose pipework that meets your unique requirements perfectly. If you are not interested in custom pipework, you can inquire about the standard ducting designs available on the market before making your purchase.
Handle with Caution
You should handle your fabricated sheet metal products with care prior to installation. Sheet metal is usually quite resilient. However, if a lot of force is exerted, the structure could develop dents and tears. As a result, the efficiency of the pipework will be compromised. Therefore, you should make certain that you have the right equipment and experienced workers for handling the sheet metal ducting. Caution while handling should minimise the risk of damage. Also, if you would like to store the piping on your site before installation, you must choose a protected space to avoid water damage, accidental impact, and extreme temperatures.
Seal the Seams
When installing the sheet metal piping, you will need to join multiple sections to create a continuous conveyance system. In simple terms, it is not possible to cover an entire building using one single pipe. It would be impractical to produce a long pipe because it would be difficult to fabricate, transport, and handle. Unfortunately, using short duct runs during your project can also present some challenges. The primary concern is the potential for leakage through the connection points. If the seams are not tightly connected, there will be a point of weakness in the system. Therefore, you should plan for the sealing of these seams. The joints can be welded or sealed using a speciality sealant to prevent the occurrence of leaks during the service life of the pipework.